Filter
Top Products
2-12 SmartCell ZX-250 User Guide
Switch Configuration Switch Installation and Setup
Figure 2-9 ZX-250 console and network connections
T• Start the dumb terminal or PC and its terminal emulation software; then turn on the ZX-250 switch.
Q• As the SmartCell ZX-250 powers up, a series of diagnostic messages appears on the terminal’s
screen.
–• After the diagnostics are finished, the switch prompts for a password. Enter the default password,
“admin.”
•• 0…iÊÃ݈ÍV…Ê«Àœ“«ÍÃÊvœÀÊÍ…iʈ˜vœÀ“>͈œ˜Ê˜iViÃÃ>ÀßÊ͜ʓ>ŽiÊÍ…iÊÃ݈ÍV…Ê>VViÃÈL•iÊÍ…ÀœÖ}…ÊßœÖÀÊ.Í…iÀ˜iÍÊ
˜iÍÝœÀŽ°
U Switch name
U IP address
U Subnet mask
Once you enter these parameters and reboot the switch, you can log off the local console connection. You can perform
all additional configuration over your network using a telnet connection.
2p›F Only one console connection is allowed at any time. To reach the SmartCell
ZX-250 through telnet, you must exit the local terminal connection by entering the
exit command.
NO SYNC
DATA
MON
DIAG
RX DATAPOWERSTATUSFAILRESET
TX DATA
TERMINAL ETHERNET
1 2 3 4
NO SYNC
DATA
1 2 3 4
NO SYNC
DATA
NO SYNC
DATA
1 2 3 4
C
A
D
B
TEST
ZX-250
Terminal
Ethernet
Hub
Terminal
RJ-45
Port
Ethernet
RJ-45
Port