Filter
Top Products
3-4 SmartCell ZX-250 User Guide
Creating an Emulated LAN IP Over ATM and LANE
s• Enter the start LECS command to activate LANE server services on this switch.
SmartCell ZX # start lecs
NOTICE - 'LECS' ***** LECS started *****
SmartCell ZX #
¢• Create an ELAN on your SmartCell ZX-250 switch by executing the add elan command. The
following is an example.
SmartCell ZX # add elan
ELANNumber(0) : 1
<1 is used instead of the default, (0)
ELANName(ELAN001): Marketing
<ELAN is named Marketing instead of the default, (ELAN000)
ConnectMethod(SVC):
ELANType(802.3)
<The default (Ethernet) is used
Multipoint(YES) :
MTU(1516) :
Distribute(PROXY) :
SmartCell ZX #
•• Create a client for the switch on the ELAN. For example, enter
SmartCell ZX # add laneclient
ClientNumber(0) :1
<One is used instead of the default, (0)
LanName(ELAN001) : Marketing
< ELAN name is Marketing, not the default, (ELAN001)
ServerType(LECS) :
ServerAddress()
<No LANE server address is specified; see note below
IPAddress() : 90.1.1.1
< IP address and subnet mask are included only as examples
NetMask(255.0.0.0): 255.255.255.0
MTU(1516) :
SmartCell ZX #
2p›F The command add laneclient always prompts you with a subnet mask that is
appropriate for the IP address. However, if necessary, you can change the subnet
mask to correspond to the strategy employed within your networks.
2p›F When you create a client, it automatically finds the LECS address using ILMI.
As the local client joins the ELAN, the following messages are sent to the Event log:
NOTICE - 'ZLESSRV' LES Join 39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:D4:
14:41:82:00
NOTICE - 'ZLESSRV' BUS Connect 39:00:00:00:00:00:00:00:00:00:14:41:80:00:20:D4:
14:41:82:00
%"¤›apm Never create an ELAN (or ELAN client) with the same subnet as the SmartCell
ZX-250 Ethernet port.