Filter
Top Products
28
Chapter 2 Connecting to a Computer
●The SCSI ID default is set to 2.
●Assign SCSI ID numbers ranging from 0 to 7 for each SCSI device. Do not select 7 as
this is normally assigned to the SCSI controller. If a SCSI hard disk is mounted, do
not use 0 and 1. Normally 0 and 1 are assigned for hard disks.
Set the terminator on the last SCSI device on a daisy chain to ON.
<When only the scanner is connected to your computer, or when another
SCSI device is connected on a daisy chain and the scanner is the last SCSI
device on the end of the daisy chain>
Set the terminator switch on the scanner to ON.
In such a connection, be sure to set the terminator on all other SCSI devices to
OFF.
Terminator OFF
Terminator ON
<When another SCSI device is connected as the last device of the daisy
chain>
Set the terminator switch on the scanner to OFF.
In such a connection, set the terminator on the SCSI device connected as the end
device to ON.
Terminator ON, or
attach terminator.
Terminator OFF
Ferrite Core
When connecting to another SCSI device sequentially after connecting a SCSI cable to
the scanner, be sure to attach the ferrite core to the SCSI cable. If you use the scanner
without attaching the ferrite core, radio wave interference may occur.
Important
CAUTION