Filter
Top Products
63
ENGLISH
Using the Count Only Mode
In the Count Only Mode, document pages are sent through the feeder in order to
count them. The document is not scanned. You can perform Count Only Mode
operations on the scanner, without using your computer.
1
Use the user modes to enter the scanner's Count Only Mode.
(See “How to Set the User Modes,” on p. 72.)
This causes the Start key lamp to light green.
2
Load the document into the feeder, and then press the [Start] key.
This sends the pages of the document through the feeder and counts them.
3 After all of the document pages are fed, exit the Count Only Mode.
(See “How to Set the User Modes,” on p. 72.)
To clear the page count from the display panel, hold down the [Stop] key
for approximately two seconds.
4.4 Other Scanning Techniques