Preface
v
CONNECTION OF THE EQUIPMENT
This equipment complies with Part 68 of the FCC rules. On the rear panel
of this equipment is a label that contains, among other information, the
FCC Registration Number and Ringer Equivalence Number (REN) for
this equipment. If requested, this information must be given to the
telephone company. This equipment may not be used on coin service
provided by the telephone company. Connection to party lines is subject
to state tariffs.
An FCC compliant telephone cord and modular jack is provided with this
equipment. This equipment is designed to be connected to the telephone
network or premises wiring using a compatible modular jack which is
Part 68 compliant. See Installation Instructions for details.
This REN is used to determine the quantity of devices which may be
connected to the telephone line. Excessive REN’s on the telephone line
may result in the devices not ringing in response to an incoming call. In
most, but all areas, the sum of the REN’s should not exceed five(5.0). To
be certain of the number of devices that may be connected to the line, as
determined by the total REN’s, contact the telephone company to
determine the maximum REN for the calling area.
IN CASE OF EQUIPMENT MALFUNCTION
Should any malfunction occur which cannot be corrected by the
procedures described in this User’s Guide, disconnect the equipment
from the telephone line or unplug the power cord. The telephone line
should not be reconnected nor the power cord plugged in until the
problem is completely resolved. Users should contact their local
authorized Canon Facsimile Dealer for servicing of equipment.
RIGHTS OF THE TELEPHONE COMPANY
Should the equipment cause harm to the telephone network, the
telephone company may temporarily disconnect service. The telephone
company also retains the right to make changes in facilities and services
which may affect the operation of this equipment. When such changes are
necessary, the telephone company is required to give adequate prior
notice to the user.