Filter
Top Products
COPYRIGHT
©
2001 CANON INC. 2000 2000 2000 2000 CANON iR2200/iR2800/iR3300 REV.0 MAR. 2001
CHAPTER 8 PAPER DECK-L1
8-36 P
3.3.7 Routing the Lifter Cable
1) Check to make sure that the lifter drive shaft [1] and the lifter [2] are kept in place by
means of a hex wrench [3] and two long screwdrivers [4].
2) Fix the four cable fixing plates [5] in place to the lifter using two screws each.
3) Hook the lifter cable [6] on the four pulleys [7].
4) Hook the ball of the lifter cable on the two pulleys [8] at the front/rear of the lifter drive
shaft; then, wind it along the groove of the pulley about 1.5 turns. At this time, be sure
to keep the lifter cable taut so that the long screwdrivers used to keep the lifter in posi-
tion will move up and stop.
5) In this condition, secure the two pulleys [5] in place to the lifter drive shaft using a set
screw [9] (1 each).
6) Mount the pulleys [8] to the lifter drive shaft; then, measure the distance from the base
plate of the compartment to the top face of the lifter, making sure that the lifter is level.
F08-303-12
[4]
[8]
[9]
[5]
[7]
[7]
[5]
[1]
[2]
[5]
[9]
[8]
[3]
[5]
[6]