Filter
Top Products
II. UNPACKING AND INSTALLING THE COPIER
When a metal part is brought in from a cold to warm environment, droplets of water
can develop on the surface of the part. This phenomenon is called condensation, and
condensation in a copier can lead to faulty images. If the copier has been moved from a
cold to warm place, leave it alone for about one hour or more before unpacking it.
A. Unpacking and Removing Fixings
Work
Unpack the copier.
Detach the plastic cover, and
place the copier on the
pedestal holding its grips; be
sure to work in a group of two.
Install the Cassette Feeding
Module-B2 or -A2 (accessory)
according to its Installation
Procedure if the copier is to be
placed on it.
Open the cardboard box, and
take out all the accessories.
Remove all tape from the
outside of the copier. Take out
the cassette from the cardboard
box, and remove the cushions
from inside the cassette; then,
slide the cassette into the copier.
Remove the tape from the
scanner fixing found on the
outside of the left cover,
remove the screw, and slide the
fixing to the right to detach it to
the front.
• Keep the fixing stored for
possible relocation of the
machine.
Remarks
Check that none of the following accessories is missing:
•
Copy tray
•
Installation Procedure
•
Cassette (Universal)
•
Operator’s Manual
Make sure that the paper size plate and size label
(1 pc. each) is inside the cassette.
Step
1
2
3
4
5
COPYRIGHT
©
1997 CANON INC. CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
8-2
CHAPTER 8 INSTALLATION