Filter
Top Products
CHAPTER 10 TROUBLESHOOTING
10-103
COPYRIGHT
©
1997 CANON INC. CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)
No.
311
312
313
314
315
316
317
318
319
Description
Left/right margin adjustment
(Direct; home position for slide
shutter for blank exposure)
Left/right margin adjustment
(Reduce; travel distance of slide
shutter for blank exposure)
Primary output voltage correction
(corrects output voltage
determined by APVC)
APVC measured current shift
(corrects the results of APVC)
Voltage correction for
measurement in APVC (corrects
voltage for measurement applied
at time of APVC)
Measurement current correction
for APVC (corrects current
measured at time of APVC)
Fluorescent lamp pre-heating
current adjustment
Transfer output voltage
adjustment (corrects transfer
voltage determined by ATVC)
Arch adjustment when
multifeeder is used (pick-up roller
OFF timing)
Remarks
A higher setting increases the
margin on both left and right.
default: 8
unit: 0.27 mm
A higher setting increases the
margin on both left and right.
default: 0
unit: 0.27 mm
Enter the setting recorded on the label
after replacing the drum cartridge.
Enter the setting recorded on the label
after replacing the drum cartridge.
default: 0
unit: 16 V
Enter the value recorded on the label
on the composite power supply when
replacing the composite power supply.
default: 0
Enter the value recorded on the
label on the composite power
supply when replacing the
composite power supply.
default: 0
Enter the value recorded on the
label on the composite power
supply when replacing the
composite power supply.
Convert the value recorded on the
label on the composite power
supply as follows and change the
value recorded on the service label;
then, enter the value when replacing
the composite power supply.
Label Input Label Input
1
→ 06→+1
2 → -1 7 → +2
3 → -2 8 → +3
4 → -3 9 → +4
5 → -4
A higher setting increases the arch.
default: 25
unit: 0.27 mm
Settings
0 ~ 15
-10 ~ +10
-16 ~ +16
-40 ~ +40
-16 ~ +16
-10 ~ +10
-9 ~ +9
-4 ~ +4
0 ~ 63