Filter
Top Products
7) Fix the harness in place using two SK binders (WT2-5145; front, rear) t; then, insert
it into the transfer guide.
Caution:
When fixing the harness in place, make sure that the cap portions of the terminals
alternate; keeping them in parallel will bring them in contact with the transfer roller.
8) Fix the harness with two SK binder t (front, rear) in place, and insert it into the
transfer guide.
Figure 10-229
9) Connect the connector y as shown in Figure 10-230.
Figure 10-230
Caution:
When attaching the transfer guide to the copier after attaching the drum heater,
make sure that the spring at the rear is firmly in the groove.
10-24
CHAPTER 10 TROUBLESHOOTING
COPYRIGHT
©
1997 CANON INC. CANON NP6218 REV. 0 MAY 1997 PRINTED IN JAPAN (IMPRIME AU JAPON)