Filter
Top Products
1-17
FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine
Chapter 1 FAQs and Troubleshooting
Devices FAQs and Troubleshooting
a. Use the procedures in the configuration template instructions in the
online help or the User Guide for the CiscoWorks Wireless LAN Solution
Engine, 2.5 to create a template.
b. Enter the following custom values in the template:
snmp-server view iso iso included
snmp-server community community_string view iso RO
c. Run a configuration job on the devices in the Misconfigured Devices
group:
— Select the template created in the previous step.
—Either select the Misconfigured Devices group or the devices in the
group.
—Schedule the job to run at the desired time.
d. After the configuration job finishes successfully, the dot11 mib fault will
be cleared after the next discovery cycle. You can run a manual discovery
immediately after the configuration job finishes; select Devices >
Discover > Run Inventory > Run Now.
–
Perform the following steps on the WLSE:
a. If the device’s ISO community string has not been entered on the WLSE,
select Devices > Discover > Device Credentials > SNMP Communities.
Then, enter the same community strings that you configured on the
devices in the previous procedure.
Otherwise, the devices will be placed back in the Misconfigured Devices
group after the next discovery cycle.
b. Rediscover the devices by using them as seed devices in an immediate
discovery. Select Devices > Discover > Run Inventory > Run Now. For
more information on discovery, see the online help discovery section or
the User Guide for the CiscoWorks Wireless LAN Solution Engine,
Release 2.5.