Filter
Top Products
2-7
FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine
Chapter 2 Fault Descriptions
Access Point Faults
EAP per SSID is
disabled
Non-IOS
and IOS
EAP per SSID has
been disabled on
the access point.
When this fault is
cleared, the
following message
displays: EAP per
SSID is enabled
Manage Fault
Settings >
Security
Policies > EAP
Per SSID
Enforced
Log in to the access point
and enable the Network
EAP and Open
authentication per SSID.
Ethernet bandwidth
utilization is
Degraded
(utilization %)
Non-IOS
and IOS
The fault threshold
set for the degraded
state has been
exceeded.
When this fault is
cleared, the
following message
displays: Ethernet
bandwidth
utilization is OK.
Manage Fault
Settings >
Thresholds >
Access Point >
Ethernet Port
Utilization
Verify that the fault
threshold is set correctly.
If the threshold is set
correctly, review your
network to determine the
action necessary to clear
the fault condition.
Ethernet bandwidth
utilization is
Overloaded
(utilization %)
Non-IOS
and IOS
The fault threshold
set for the
overloaded state
has been exceeded.
When this fault is
cleared, the
following message
displays: Ethernet
bandwidth
utilization is OK.
Manage Fault
Settings >
Thresholds >
Access Point >
Ethernet Port
Utilization
Verify that the fault
threshold is set correctly.
If the threshold is set
correctly, review your
network to determine the
action necessary to clear
the fault condition.
Table 2-1 Access Point Faults (continued)
Fault Description Type Explanation Related Setting Recommended Action