Filter
Top Products
Chapter 2 Fault Descriptions
Access Point Faults
2-18
FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine
WDS appears down. IOS The WLSE failed to
receive “keep
active” messages
from the WDS.
This happens when
the WDS is down or
when the network is
down.
Manage Fault
Settings >
Thresholds >
WDS >
WLSE-WDS
Link Status
Check the network
connectivity, the WDS
status, and the WLSE and
WDS credentials.
WEP Error is in
Degraded state (error
rate %)
Non-IOS
and IOS
The fault threshold
set for the degraded
state has been
exceeded.
When this fault has
been cleared, the
following message
displays: WEP
Error is in OK state
Manage Fault
Settings >
Thresholds >
Access Point >
RF Port WEP
Errors
Verify that the fault
threshold is set correctly.
If the threshold is set
correctly, review your
network to determine the
action necessary to clear
the fault condition.
WEP Error is in
Overloaded state
(error rate %)
Non-IOS
and IOS
The fault threshold
set for the
overloaded state
has been exceeded.
When this fault has
been cleared, the
following message
displays: WEP
Error is in OK state
Manage Fault
Settings >
Thresholds >
Access Point >
RF Port WEP
Errors
Verify that the fault
threshold is set correctly.
If the threshold is set
correctly, review your
network to determine the
action necessary to clear
the fault condition.
WEP is disabled Non-IOS
and IOS
WEP has been
disabled.
When this fault has
been cleared, the
following message
displays: WEP is
enabled.
Manage Fault
Settings >
Security
Policies > WEP
Enforced
Log in to the access point
and enable WEP.
Table 2-1 Access Point Faults (continued)
Fault Description Type Explanation Related Setting Recommended Action