Filter
Top Products
2-25
FAQ and Troubleshooting Guide for the CiscoWorks Wireless LAN Solution Engine
Chapter 2 Fault Descriptions
Switch Faults
Switch Faults
Table 2-4 Switch Faults
Fault Description Explanation Related Setting Recommended Action
CPU utilization is
Degraded (utilization %)
The fault threshold
set for the degraded
state has been
exceeded.
When this fault has
been cleared, the
following message
displays: CPU
utilization is Ok.
Manage Fault
Settings >
Thresholds >
Switch > CPU
Utilization
Verify that the fault
threshold is set correctly.
If the threshold is set
correctly, review your
network to determine the
action necessary to clear
the fault condition.
CPU utilization is
Overloaded
(utilization %)
The fault threshold
set for the overloaded
state has been
exceeded.
When this fault has
been cleared, the
following message
displays: CPU
utilization is Ok.
Manage Fault
Settings >
Thresholds >
Switch > CPU
Utilization
Verify that the fault
threshold is set correctly.
If the threshold is set
correctly, review your
network to determine the
action necessary to clear
the fault condition.
Device was not reachable
via SNMP
The SNMP Agent on
the switch is down.
When this fault has
been cleared, the
following message
displays: Device was
reachable via SNMP.
Manage Fault
Settings >
Thresholds >
Switch > SNMP
Reachable
Make sure that the switch
SNMP agent is active.
Module is down The module is down.
When this fault has
been cleared, the
following message
displays: Module is
up.
Manage Fault
Settings >
Thresholds >
Switch > Module
Status
Check the module in the
switch and correct the
problem.