Filter
Top Products
Implementing IS-IS on Cisco IOS XR Software
Where to Go Next
RC-124
Cisco IOS XR Routing Configuration Guide
Where to Go Next
To implement more IP routing protocols, see the following document modules:
• Implementing OSPF on Cisco IOS XR Software
• Implementing BGP on Cisco IOS XR Software
Additional References
The following sections provide references related to implementing IS-IS on Cisco IOS XR software.
Related Documents
Standards
MIBs
Related Topic Document Title
IS-IS commands: complete command syntax,
command modes, command history, defaults, usage
guidelines, and examples
Cisco IOS XR Routing Command Reference, Release 3.2
MPLS TE feature information Implementing MPLS Traffic Engineering on Cisco IOS XR Software
module in the Cisco IOS XR Multiprotocol Label Switching
Configuration Guide, Release 3.2
Standards Title
Draft-ietf-isis-ipv6-05.txt Routing IPv6 with IS-IS, by Christian E. Hopps
Draft-ietf-isis-wg-multi-topology-06.txt M-ISIS: Multi Topology (MT) Routing in IS-IS, by Tony Przygienda,
Naiming Shen, and Nischal Sheth
Draft-ietf-isis-traffic-05.txt IS-IS Extensions for Traffic Engineering, by Henk Smit and Toni Li
Draft-ietf-isis-restart-04.txt Restart Signalling for IS-IS, by M. Shand and Les Ginsberg
Draft-ietf-isis-igp-p2p-over-lan-05.txt Point-to-point operation over LAN in link-state routing protocols, by
Naiming Shen
MIBs MIBs Link
There are no applicable MIBs for this module. To locate and download MIBs for selected platforms using
Cisco IOS XR software, use the Cisco MIB Locator found at the
following URL:
http://cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml