Filter
Top Products
Implementing OSPF on Cisco IOS XR Software
How to Implement OSPF on Cisco IOS XR Software
RC-152
Cisco IOS XR Routing Configuration Guide
Step 5
network {broadcast | non-broadcast |
{point-to-multipoint [non-broadcast] |
point-to-point}}
Example:
RP/0/RP0/CPU0:router(config-ospf-ar)# network
non-broadcast
Configures the OSPF network type to a type other than the
default for a given medium.
• The example sets the network type to NBMA.
Step 6
dead-interval
seconds
Example:
RP/0/RP0/CPU0:router(config-ospf-ar)#
dead-interval 40
(Optional) Sets the time to wait for a hello packet from a
neighbor before declaring the neighbor down.
Step 7
hello-interval
seconds
Example:
RP/0/RP0/CPU0:router(config-ospf-ar)#
hello-interval 10
(Optional) Specifies the interval between hello packets that
OSPF sends on the interface.
Step 8
interface
type instance
Example:
RP/0/RP0/CPU0:router(config-ospf-ar)# interface
POS 0/2/0/0
Enters interface configuration mode and associates one or
more interfaces for the area configured in Step 4.
• In this example, the interface inherits the nonbroadcast
network type and the hello and dead intervals from the
areas because the values are not set at the interface
level.
Command or Action Purpose