Filter
Top Products
96 user’s guide
replacing or adding a drive
The steps to replace or add a drive are the same for both the S0000 and 8000
series, except when you are replacing a diskette drive on the 8000 series, or the
7-In-1 memory card reader on the S0000 series.
If you are replacing a diskette drive on the 8000 series, before starting step 1 in
the following instructions, you need to fit the diskette drive in a diskette drive
adapter as described in “reassembling the diskette adapter” on page 98.
If you are replacing a 7-In-1 memory card reader, before starting step 1 in the
following instructions, reassemble the reader in the drive bay adapter as
described in step 7 of “removing a drive” on page 91.
If you are replacing or adding any other drive, begin with step 1 in the following
instructions.
to replace or add a drive
1 Insert four guide screws into the sides of the drive (two on each side). The
screws help guide the drive into its proper position in the bay.
• When replacing a drive on the S0000 and 8000 series, place the screws, that
you removed from the old drive, into the new drive.
• When adding a second hard disk drive on the 8000 series, use the four
extra guide screws that are attached to the chassis under the front bezel.
2 Slide the drive into the drive bay (1), making sure to align the guide screws
with the guide slots, until it snaps into place.
sliding the drive into the drive bay on the S0000/8000 (S0000 shown)