Filter
Top Products
System
Configuration
S900II
I – Memory
1
01T01350_0
2.2.98
I – MEMOR
Y
I – 1. Accessing the memory
After
accessing ”Memory Management” by pressing [Memo_M] (programming menu), pressing the
[M_Read] key gives access to the read (or modification) function of the user and system RAM or
EEPROM memory (at the address of the memory box by default if necessary).
The
address of the
area at which reading is to begin is given in hexadecimal (0 to F) using the numerical
keypad and the first row of alphanumerical keys of the keyboard.
Certain areas are directly accessible from the keyboard :
: beginning of the PRG editing area (0 x 006 430).
: beginning of the PLC editing area (0 x 009 430).
: beginning of the program storage in RAM area (0 x 00B 300).
: beginning of the MODULE where the programs are stored (0 x 800 000).
: transfer buffer PRG E17.
: robot serial number in RAM.
: RAM access password.
: beginning of parameters in RAM.
: beginning of the faults 200 to 204 message table in RAM.
For example
: to access the beginning of the program storage area, the procedure is as follows :
[Memo_M] –> [M_Read] –> [Address] –>
*
The keys
:
"
[ + ] or [ – ] to change addresses 2 by 2.
"
[ ]
or
[ ]
to change addresses 10 by 10 (hexadecimal).
"
[PG DN] or [PG UP] to change addresses 100 by 100 (hexadecimal).