Filter
Top Products
Chapter 3 - Handling of Control Panel CDP 31x
IV A 3 - 2 DCS 500B / DCP 500B Operating Instructions
3.2 Start Mode
Note: The CDP 31x can be connected to the drive without dis-
connecting the auxiliary power !
When connected and power is applied to the electronics, the dis-
play of the CDP 31x shows:
- software version of the Control Panel
- ID number of the CDP 31x and number of drives connected to
the link.
ID-NUMBER 31
CDP310 PANEL
TOTAL 1 DRIVES
ID-NUMBER 1
DCS 500
Display with CDP 310 / CDP 311 Display with CDP 312
After two seconds the display will clear, and the actual signals of
the selected drive will appear.
The following message is displayed if the CDP 31x is not able to
communicate with the drive:
**FAULT**
NO COMMUNICATION
NO COMMUNICATION [x]
[x]
1 The CDP is not active for 10 s
2 The drive is not active for 10 s
3 No data set received for 2 s
4 Bus administrator is offline
• The drive is not present on the link. This is the case if the drive
stops communicating.
• The link does not operate because of a hardware malfunction or
a cabling fault.
Action: Disconnect the
CDP 31x and connect it again to the
drive. By this means the
CDP 31x will be forced to
the Start Mode another time!
3ADW000055R0401_DCS500B_Operating Instruction_e_d