Filter
Top Products
1-8 Dell OptiPlex GX
pro
Systems Service Manual
SMART Support
The system has SMART-compliant hard-disk drives and SMART support in the
system BIOS, which warns you at system start-up if a hard-disk drive has
become unreliable.
S
ystem Unit
The following subsections provide service-related information about the system
unit.
System Power Supply
The 230-W system power supply can operate from an AC power source of
115 VAC at 60 Hz or 230 VAC at 50 Hz. The system power supply provides the
DC operating voltages and currents listed in Table 1-1.
NOTE: The power supply produces DC voltages only under its loaded condi-
tion. Therefore, when you measure these voltages, the DC power connectors
must be connected to their corresponding power input connectors on the system
board or drives.
.
.
Pin Assignments for the DC Power Connectors
The power-supply output voltages can be measured at the back (wire side) of
the connectors without disconnecting them. The following illustrations show
the wire side of the connectors.
Table 1-1. DC Voltage Ranges
Voltage Range
Maximum Output
Current
1
+3.3 VDC +3.15 to +3.45 VDC 14.0 A
+5 VDC +4.75 to +5.25 VDC 29.0 A
+12 VDC +11.40 to +12.60 VDC
6.0 A
–12 VDC –10.80 to –13.20 VDC 0.3 A
–5 VDC –4.50 to –5.50 VDC 0.3 A
+5 VFP
2
+4.75 to +5.25 VDC 10 mA
1
Maximum continuous DC output power shall not exceed 230 W. Maximum combined
load on +5 VDC and +3.3 VDC shall not exceed 170 W.
2
VFP (volts flea power) — sometimes called “standby power.”