Filter
Top Products
System Setup Program A-5
Power Management With the Power Management category
enabled, DPMS monitors and most EIDE
drives automatically switch into low-power
mode during periods of system inactivity.
CAUTION: Before enabling this feature,
check the monitor documentation to make
sure the system has a DPMS-compliant
monitor. Otherwise, there is a risk of dam-
aging the monitor.
NOTE: Not all EIDE hard-disk drives support
this feature. Enabling this feature for drives
that do not support it may cause the EIDE
drive to become inoperable until the system is
restarted and the Power Management category
is disabled.
Sound Enables (On [default]) or disables (Off) the
audio controller.
NIC Enables (On) or disables (Off) the network
interface controller.
Mouse Enables or disables the built-in PS/2-
compatible mouse port.
Serial Port 1
Serial Port 2
Configures system’s built-in serial ports.
Parallel Port Configures system’s built-in parallel port. The
port’s I/O address may be set to 278H, 3BCH,
or 378H.
Otherwise, the port may be dis-
abled.
Parallel Modes Controls whether system’s built-in parallel port
acts as an AT-compatible (unidirectional) or
PS/2-compatible (bidirectional) port.
IDE Hard Disk Enables system’s built-in EIDE hard-disk drive
interface.
Diskette Enables system’s built-in diskette controller.
USB Enables (On) or disables (Off
[default]) the
USB connectors.
NOTE: This category appears only on GXpro
systems containing the 10/100-Mbps Ethernet
NIC.
Speaker Enables on-board speaker.
Table A-1. System Setup Categories
(continued)
Category
Function