Filter
Top Products
Installing the Bezel
1. Snap the two tabs on the lower inside edge of the bezel into the corresponding clips on the system front panel, and pivot the bezel upward to its
closed position.
2. Using the system key, lock the bezel.
System Cover
To upgrade or troubleshoot the system, remove the cover to gain access to internal components.
Removing the Cover
1. Remove the bezel (see "Removing the Bezel").
2. Loosen the three thumbscrews on the left-side cover (see Figure5-3).
3. Grasp the cover at both ends and slide it toward the front of the system.
4. Lift the cover away from the system.
Figure 5-3. Removing the Cover
Installing the Cover
1. Ensure that no tools or loose parts are left inside the system.
2. Fit the cover on the side of the system, and slide the cover backward.
3. Tighten the three cover thumbscrews (see Figure5-3).
4. Replace the bezel.
Baffle
CAUTION: Before you perform this procedure, see "Safety First—For You and Your System."
NOTICE: Figure5-3 shows the system standing upright as the cover is being removed. However, before you service components inside the system, lay
the system on its right side.