Filter
Top Products
8. Connect a DC power cable connector to the drive's power input connector (see Figure7-3).
9. Connect the interface cable to the drive (see Figure7-3) and to the system board or controller card:
l Figure7-4 illustrates a common cable configuration for externally accessible IDE drives.
l Figure7-5 illustrates a SCSI tape drive connected to the SCSI controller on the system board.
l Figure7-6 shows a SCSI tape drive connected to a SCSI controller card.
If necessary, temporarily remove the baffle to allow easier routing of the interface cable (see "Removing the Baffle" in "Troubleshooting Your
System").
For information about the controller card, see the documentation that accompanied the card.
Figure 7-4. Connecting an IDE CD Drive and Optional IDE Tape Drive to the Integrated IDE Controller
Figure 7-5. Connecting an SCSI Tape Drive to the Integrated SCSI Controller