Filter
Top Products
System Setup Program A-1
$33(1',;$
6\VWHP6HWXS3URJUDP
This appendix describes the System Setup program, which is used to change
the system configuration information stored in NVRAM on the system board.
To enter the System Setup program, follow these steps:
F2 =
Setup
NOTE: An alternate way to enter the System Setup program is to press the
<Ctrl><Alt><Enter> keys instead of the <F2> key.
The message
Entering Setup
appears and is soon replaced by Page 1
of the System Setup screens.
If you wait too long to press the <F2> key, the F2 = Setup
message dis-
appears and your operating system begins to load into memory. If this
situation occurs,
let the system complete the load operation
; then shut it
down and try again.
NOTE: To ensure an orderly system shutdown, consult the documentation
that accompanied the operating system.