Filter
Top Products
3-6 Dell Precision 410 Systems Service Manual
Alert! Proces-
sor thermal
probe failure
detected.
Processor or
system board has
failed.
Faulty processor or
defective system board.
Alert! Second-
ary processor
is out of rev.
System detected that
the secondary proces-
sor is not the correct
revision. If the system
contains more than
512 MB of RAM, this
message will be fol-
lowed by a System
Halted message.
Processor is a type not
supported by Dell.
Alert! Single-
bit memory
error previ-
ously detected
in XXXXh.
Single-bit ECC error
was detected during
the previous operating
session.
Faulty or improperly
seated DIMMs or defec-
tive system board.
Alert! System
fan was not
detected.
System fan was not
detected.
No fan installed, defec-
tive fan, or fan cable not
connected.
Alert! Unbuf-
fered and
registered
SDRAM DIMMs
cannot be
mixed.
Mixing of unbuffered
and registered SDRAM
DIMMs is not
supported.
Two different types
(unbuffered and regis-
tered) of SDRAM DIMMs
have been installed
together and may not be
compatible.
Alert! Uncor-
rectable memory
error previ-
ously detected
in XXXXh.
Multibit ECC error was
detected during the pre-
vious operating session.
Faulty or improperly
seated DIMMs or defec-
tive system board.
Auxiliary
Device fail-
ure. Verify
that mouse and
keyboard are
securely
attached to
connectors.
System detected a
mouse failure.
Faulty mouse, or faulty
mouse controller or key-
board is attached to the
mouse connector.
Bad command or
file name
Command entered
does not exist, is faulty,
or is not in pathname
specified.
Faulty command and syn-
tax, or incorrect filename.