Dell 4300 Laptop User Manual


 
74 Adding Parts
www.dell.com | support.dell.com
FILE LOCATION:
FILE LOCATION:FILE LOCATION:
FILE LOCATION: C:\Projects\Green_Lantern_solutions\2H930c31.fm
DELL CONFIDENTIAL – PRELIMINARY 11/20/01
DELL CONFIDENTIAL – PRELIMINARY 11/20/01DELL CONFIDENTIAL – PRELIMINARY 11/20/01
DELL CONFIDENTIAL – PRELIMINARY 11/20/01
Adding Memory
CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions listed in “When Working Inside
Your Computer” on page 12.
You can increase your computer memory by installing memory modules on
the system board. For information on the type of memory supported by your
computer, see “Memory type” under “Memory” on page 91.
HINT: Memory
purchased from Dell is
covered under your
computer warranty.
1 Shut down the computer (see page 20).
2 Turn off any attached devices and disconnect them from their
electrical outlets.
NOTICE: To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network wall jack.
3
Disconnect the computer power cable from the wall outlet, and then
press the power button to ground the system board.
4 Open the computer cover (see page 65).
5If necessary, remove a memory module:
a Press out the securing clip at each end of the memory module
connector.
b Grasp the module and pull up.
If the module is difficult to remove, gently ease the module back
and forth to remove it from the connector.
2H930bk1.book Page 74 Tuesday, November 20, 2001 5:02 PM