Filter
Top Products
76 Adding Parts
www.dell.com | support.dell.com
FILE LOCATION:
FILE LOCATION:FILE LOCATION:
FILE LOCATION: C:\Projects\Green_Lantern_solutions\2H930c31.fm
DELL CONFIDENTIAL – PRELIMINARY 11/20/01
DELL CONFIDENTIAL – PRELIMINARY 11/20/01DELL CONFIDENTIAL – PRELIMINARY 11/20/01
DELL CONFIDENTIAL – PRELIMINARY 11/20/01
NOTICE: To connect a network cable, first plug the cable in to the network
wall jack and then plug it in to the computer.
11
Right-click the My Computer icon and then click Properties.
12 Click the General tab.
13 To verify that the memory is installed correctly, check the amount of
memory (RAM) listed.
Replacing the AGP Card
CAUTION: Before you begin any of the procedures in this section,
follow the safety instructions listed in “When Working Inside
Your Computer” on page 12.
1
Shut down the computer (see page 20).
2 Turn off any attached devices and disconnect them from their
electrical outlets.
NOTICE: To disconnect a network cable, first unplug the cable from your
computer and then unplug it from the network wall jack.
3
Disconnect the computer power cable from the wall outlet, and then
press the power button to ground the system board.
4 Open the computer cover (see page 65).
5 Press the card clip lever on the side of the AGP card to release the card
from the slot connector, and remove the card.
card clip
lever
AGP card
AGP card clip
slot connector
back of computer
2H930bk1.book Page 76 Tuesday, November 20, 2001 5:02 PM