Filter
Top Products
Appendix 97
Replacing the Battery
CAUTION: Before you begin this procedure, follow the safety
instructions listed in “When Working Inside Your Computer” on
page 12.
A coin-cell battery maintains computer configuration, date, and time
information. The battery can last several years.
If you have to repeatedly reset time and date information after turning on
the computer, replace the battery.
CAUTION: A new battery can explode if it is incorrectly installed.
Replace the 3-V CR2032 battery only with the same or equivalent
type recommended by the manufacturer. Discard used batteries
according to the manufacturer’s instructions.
1
Record all the screens in the system setup program (see page 95) so
that you can restore the correct settings in step 7.
2 Open the computer cover (see page 65).
3 Locate the battery socket BATTERY (see page 68).
4 Remove the battery by carefully prying it out of its socket with your
fingers or with a blunt, nonconducting object such as a plastic
screwdriver.
NOTICE: To avoid damage to the system board while you pry the battery
loose, be sure to insert the plastic screwdriver between the battery and the
socket (not the system board).
5 Insert the new battery into the socket with the side labeled “+” facing
up and snap it into place.
battery socket
(BATTERY)
battery
2H930bk1.book Page 97 Tuesday, November 20, 2001 5:02 PM