Filter
Top Products
Installing and Configuring SCSI Drivers 3-9
BIOS Support For Int13 Extensions This option determines whether the
host adapter BIOS supports disks with more than 1024 cylinders. The default is
Enabled.
,QVWDOODWLRQIRU6XSSRUWHG:LQGRZV17
6HUYHU2SHUDWLQJ6\VWHPV
This section provides the following information about installing the Dell SCSI drivers
for the supported Windows NT Server operating systems (for a list of the operating
systems supported see Supported Operating Systems in Chapter 1):
Installing the SCSI drivers
Removing a host adapter
Swapping a host adapter
Troubleshooting a configuration if Windows NT fails to boot
NOTE: Refer to Dells Microsoft Windows NT Server 4.0 Operating System Quick
Installation Guide or
Microsoft Windows NT Server, Enterprise Edition 4.0 Installation
Information for instructions for installing or reinstalling the Windows NT operating
system on your server. The following procedures focus specifically on the installation
of SCSI drivers.
,QVWDOODWLRQ2YHUYLHZ
The Windows NT driver diskettes you create for the Microsoft Windows NT Server
operating system contain a number of files needed for driver installation. The follow-
ing files are included on the diskettes:
aic78u2.sys Adaptecs driver for the 7890 SCSI controller and the
AHA-2940U2W host adapter for Windows NT
aic78xx.sys Adaptecs driver for the 7860 SCSI controller for Windows NT
oemsetup.inf A file used by Windows NT Setup for driver installation
readme.txt A text file describing the Adaptec 78
xx
driver for Windows NT
If you have an optional RAID controller, you will also be using the pedge.sys file, the
Windows NT driver for the RAID controller. Depending on the RAID controller you
have, the driver may be on the
Dell OpenManage Server Assistant
CD or on a sepa-
rate diskette included with the shipment.
3502Ebk0.book Page 9 Friday, November 13, 1998 10:00 AM