Dell 4350 Server User Manual


  Open as PDF
of 148
 
Installing and Configuring SCSI Drivers3-15
&UHDWLQJWKH,QWUDQHW:DUH'ULYHU'LVNHWWHV
If you have not already done so, use the
Dell OpenManage Server Assistant
CD to cre-
ate the IntranetWare SCSI and RAID drivers diskette. Refer to the
Dell OpenManage
Server Assistant
CD to create this diskette.
If you have a RAID controller installed, you may have a RAID driver diskette included
with your shipment. If so, use that diskette as the source of your RAID driver rather
than the SCSI and RAID drivers diskette created from the
Dell OpenManage Server
Assistant
CD.
NOTE: Label all driver diskettes. (For example, use the label IntranetWare 4.11 Driver
Updates).
Once the diskettes are created, continue to the next subsection, Preparing the
Hard-Disk Drive for IntranetWare Installation.
3UHSDULQJWKH+DUG'LVN'ULYHIRU,QWUDQHW:DUH
,QVWDOODWLRQ
To prepare the hard-disk drive for IntranetWare installation, you must create a utility
partition on the drive, create the primary MS-DOS partition, format the MS-DOS parti-
tion, create the c:\dos and c:\scsi subdirectories, and install certain system files.
You do not need to create a utility partition if you are installing IntranetWare on your
system for the first time. Dell shipped your system with the utility partition already
created on the hard-disk drive; you can proceed to create the primary MS-DOS parti-
tion on the drive. If you are reinstalling IntranetWare, you will need to delete the utility
partition and re-create it.
&$87,21'RQRWSHUIRUPWKHVHSURFHGXUHVLI'HOOLQVWDOOHG,QWUDQHW
:DUHRQ\RXUV\VWHP7KH'HOOLQVWDOOHGYHUVLRQRI,QWUDQHW:DUH
DOUHDG\FRQWDLQVWKH6&6,GULYHUV\RXQHHG,I\RXSDUWLWLRQDQGIRUPDW
GULYHVWKDWDOUHDG\FRQWDLQGDWDWKHGDWDZLOOEHRYHUZULWWHQDQGFDQQRW
EHUHWULHYHG
Follow these steps to prepare the hard-disk drive using the
Dell OpenManage Server
Assistant
and
Dell IntranetWare Support
CDs:
1. Perform the following steps to create a utility partition:
a. Insert the
Dell OpenManage Server Assistant
CD into the servers CD-ROM
drive and turn on (or reboot) the system.
b. From the
Dell OpenManage Server Assistant
CD main menu, select Create
utility partition and press <Enter>.
c. At the Welcome screen, select OK and press <Enter>.
d. At the message
,QVWDOODWLRQFRPSOHWHGVXFFHVVIXOO\
, select OK
and press <Enter>.
e. Select Exit and press <Enter>.
3502Ebk0.book Page 15 Friday, November 13, 1998 10:00 AM
 previous next