Filter
Top Products
4-16 Dell PowerEdge 4350 Systems Users Guide
'LVDEOLQJD)RUJRWWHQ3DVVZRUG
If you forget your system or setup password, you cannot operate your system or
change settings in the System Setup program, respectively, until a trained service
technician opens the computer chassis, changes the password jumper setting to dis-
able the passwords, and erases the existing passwords. This procedure is described
in Disabling a Forgotten Password in Appendix B of the
Installation and Trouble-
shooting Guide.
5HVSRQGLQJWR(UURU0HVVDJHV
If an error message appears on your monitor screen while the system is booting,
make a note of the message. Then, before entering the System Setup program, refer
to System Beep Codes and System Messages in Chapter 3 of the
Installation
and Troubleshooting Guide
for an explanation of the message and suggestions for cor-
recting any errors. (An exception to this routine: It is normal to receive an error
message the first time you boot your system after installing a memory upgrade. In
that situation, do not refer to System Beep Codes and System Messages.
Instead, follow the instructions in Performing a Memory Upgrade in Chapter 8 of
the
Installation and Troubleshooting Guide
.)
Some error conditions give the user the following options:
Press <F1> if you wish to continue; or
Press <F2> if you wish to run the System Setup program and update the config-
uration data.
3502Ebk0.book Page 16 Friday, November 13, 1998 10:00 AM