Filter
Top Products
Using the Resource Configuration Utility 5-3
amount of memory available to the RCU. See the documentation that accompanied
these programs for instructions on removing them from memory.
If you start the utility and there is not enough memory to run it, a message is
displayed. If you receive such a message, run the utility from a diskette.
Follow these steps the first time you use the RCU.
To run the program from a diskette
, insert into drive A the RCU diskette
that you cre-
ated from the
Dell OpenManage Server Assistant
CD. Then either turn on your
computer or reboot it by pressing <Ctrl><Alt><Del>.
1.
To run the program from your hard-disk drive
, switch to the c:\rcu subdirectory,
type
VG
at the operating system prompt, and press <Enter>.
To run the program from the
Dell OpenManage Server Assistant
CD, restart the
system from the CD and refer to the options on the CDs main menu to run the
RCU.
2. When the Welcome screen appears, read the information on the screen and
press <Enter>.
The Main Menu appears as follows:
0DLQ0HQX
/HDUQDERXWFRQILJXULQJ\RXUFRPSXWHU
&RQILJXUHFRPSXWHU
6HWGDWH
6HWWLPH
0DLQWDLQUHVRXUFHFRQILJXUDWLRQGLVNHWWH
([LWIURPWKLVXWLOLW\
The first option in the menu is already highlighted.
3. Press <Enter> to read the online overview of the RCU.
After reading the online overview, you are ready to use the program to configure
your computer for any PCI expansion cards currently installed in your computers
expansion slots.
0DLQ0HQX
The following four sections describe each of the menu options in the Main Menu and
the submenus for those options.
/HDUQ$ERXW&RQILJXULQJ<RXU&RPSXWHU
The Learn About Configuring Your Computer option presents an overview of the
configuration process. As you finish reading a screen, press <Enter> to view the next
screen. Press <F10> to return to the Main Menu.
3502Ebk0.book Page 3 Friday, November 13, 1998 10:00 AM