Filter
Top Products
I/O Ports and ConnectorsB-3
To avoid autoconfiguration, you may be able to reset jumpers on the expansion card
so that the cards port designation changes to the next available COM number, leaving
the designation for the built-in port as is. Alternatively, you can disable the built-in
ports through the System Setup program. The documentation for your expansion card
should provide the cards default I/O address and allowable IRQ settings. It should
also provide instructions for readdressing the port and changing the IRQ setting, if
necessary.
The built-in parallel port has autoconfiguration capability through the System Setup
program; that is, if you set the parallel port to its automatic configuration and add an
expansion card containing a port configured as LPT1 (IRQ7, I/O address 378h),
the system automatically remaps the built-in parallel port to its secondary address
(IRQ5, I/O address 278h). If the secondary port address is already being used, the
built-in parallel port is turned off.
For general information on how your operating system handles serial and parallel
ports, and for more detailed command procedures, see your operating system
documentation.
6HULDO3RUW&RQQHFWRUV
If you reconfigure your hardware, you may need pin number and signal information for
the serial port connectors. Figure B-2 illustrates the pin numbers for the serial port
connectors, and Table B-1 lists and defines the pin assignments and interface signals
for the serial port connectors.
)LJXUH%3LQ1XPEHUVIRUWKH6HULDO3RUW&RQQHFWRUV
¤
shell
¤
3502Ebk0.book Page 3 Friday, November 13, 1998 10:00 AM