Filter
Top Products
Using the System Setup Program 43
Super IO Configuration
USB Configuration
PCI Configuration
Option Description
Serial Port1 Address
(3F8/IRQ4 default)
Assigns the I/O address and IRQ for the first onboard
serial port.
Serial Port2 Address
(3F8/IRQ4 default)
Assigns the I/O address and IRQ for the second onboard
serial port.
Option Description
USB Devices Enabled Displays USB devices currently detected.
Legacy USB Support
(Auto default)
Enables support for legacy USB devices. Select Auto to
disable legacy support if no USB devices are connected.
USB 2.0 Controller Configures the USB 2.0 controller in HiSpeed
(480 Mbps) or FullSpeed (12 Mbps).
USB Mass Storage Reset
Delay (20 Sec default)
Sets the number of seconds that the POST waits for the
USB mass storage device after the start unit command is
issued.
Device# USB device model name.
Emulation Type (Auto
default)
If the type is set to Auto, USB devices which are
less than 530 MB are emulated as floppies and the
others are emulated as hard drives. Forced FDD option
can be used to force a formatted hard drive to boot
as FDD (e.g. ZIP drive).
Option Description
NIC1 KAWELA
(Enable with PXE
default)
Enables or disables onboard 82576 NIC1 PXE
option ROM.
NIC2 KAWELA
(Enable with PXE
default)
Enables or disables onboard 82576 NIC2 PXE
option ROM.
book.book Page 43 Friday, November 8, 2013 11:29 AM