Filter
Top Products
88 Installing System Components
4
Connect the RAID battery cable to the RAID battery connector on the
storage controller card. See Figure 3-15.
5
Close the system. See "Closing the System" on page 59.
6
Reconnect your system and peripherals to their electrical outlets, and turn
on the system.
Mezzanine Card (10 GbE LAN)
Removing the Mezzanine Card (10 GbE LAN)
CAUTION: Many repairs may only be done by a certified service technician.
You should only perform troubleshooting and simple repairs as authorized in
your product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by Dell is not
covered by your warranty. Read and follow the safety instructions that came
with the product.
1
Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2
Open the system. See "Opening the System" on page 58.
3
Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 60.
4
Remove the expansion-card riser assembly. See "Removing the Expansion-
Card Riser" on page 75.
5
Remove the three spacer pins and the screw on the mezzanine card.
6
Remove the two screws securing the bracket and remove the card.
See Figure 3-19.
7
If you are not installing another mezzanine card, install the
mezzanine-card cover and secure with two screws. See Figure 3-19.
book.book Page 88 Friday, November 8, 2013 11:29 AM