Filter
Top Products
92 Installing System Components
Figure 3-20. Removing and Installing the Power Supply
Installing the Power Supply
1
Verify that both power supplies are of the same type and have the
same maximum output power.
2
Slide the new power supply into the system until the power supply is fully
seated and the release latch snaps into place. See Figure 3-20.
3
Reconnect your system and peripherals to their electrical outlets, and turn
on the system.
NOTE: When installing, hot-swapping, or hot-adding a new power supply in a
system with two power supplies, allow several seconds for the system to recognize
the power supply and determine its status. The power-supply status indicator turns
green to signify that the power supply is functioning properly. See Figure 1-3.
1 power supply 2 release latch
3 power supply handle
1
2
3
book.book Page 92 Friday, November 8, 2013 11:29 AM