Filter
Top Products
Removing and Installing Parts 123
5
Remove the four screws securing the hard drive.
6
Slide the drive out away from the front of the computer.
7
If removing this drive changes the drive configuration, then be sure to
reflect these changes in system setup. When you restart your computer,
enter system setup (see "System Setup" on page 172), then go to the
"Drives" section of the system setup and under
Drive 0 through 3
, set the
Drive to the correct configuration.
8
Replace the computer cover (see "Replacing the Computer Cover" on
page 164).
9
Connect computer and other devices to an electrical outlet.
1 hard drive 2 power cable 3 serial ATA data cable
4 system board connector 5 screws (4)
2
4
3
1
5
book.book Page 123 Friday, April 4, 2008 12:10 PM