Filter
Top Products
128 Removing and Installing Parts
4
Disconnect the power and data cables from the back of the floppy drive.
NOTE: If you have installed a PCI Express x16 card, this card may cover the
floppy-drive connectors. Remove this card before disconnecting the floppy-
drive cables
(see
"Removing a PCI/PCI Express Card
" on page 116
).
5
Disconnect the data cable from the system board.
6
Remove the two screws securing the floppy drive.
7
Slide the floppy drive out through the front of the computer.
1 floppy drive 2 data cable 3 power cable
4 system board connector 5 screws (2)
*
Not present on all computers.
2
4
3
*1
5
book.book Page 128 Friday, April 4, 2008 12:10 PM