Filter
Top Products
176 Appendix
4
Press the up- and down-arrow keys to highlight the item you want to
change, and then press <Enter>.
5
Press the up- and down-arrow keys to select the boot device you want to
change, and then press <Enter>.
6
Press <F10> and then press <Enter> to exit system setup and resume
the boot process.
Clearing Forgotten Passwords
CAUTION: Before you begin any of the procedures in this section, follow the
safety instructions located in the Product Information Guide.
1
Follow the procedures in "Before You Begin" on page 97.
2
Remove the computer cover (see "Removing the Computer Cover" on
page 99).
3
Locate the 3-pin password connector (CLEAR P.W.) on the system board
and remove the 2-pin jumper plug from pins 2 and 3 and fix it on pins 1
and 2 and wait for approximately five seconds to clear the password.
4
Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2
and 3 to enable the password feature.
book.book Page 176 Friday, April 4, 2008 12:10 PM