Filter
Top Products
126 Removing and Installing Parts
6
Replace and tighten the four screws to secure the hard drive.
7
Connect the power and data cables to the drive.
8
Connect the data cable to the system board.
9
Check all cables to be certain that they are properly connected and firmly
seated.
10
Replace the computer cover (see "Replacing the Computer Cover" on
page 164).
NOTICE: To connect a network cable, first plug the cable into the network port or
device and then plug it into the computer.
1 second hard drive (optional) 2 serial ATA data cable 3 power cable
4 system board connector 5 screws (4)
2
4
3
1
5
book.book Page 126 Friday, April 4, 2008 12:10 PM