Filter
Top Products
Installing System Components 119
RAID Battery (Optional)
Removing the RAID Battery
The information in this section applies only to systems with the optional
PERC controller card.
1
Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2
Rotate the system feet inward and lay the system on a flat surface.
3
Open the system. See "Opening the System" on page 90.
4
Hold the touch points and lift the expansion card stabilizer away from the
cooling shroud.
5
Remove the storage controller card. See "Removing an Expansion Card" on
page 118.
6
To disconnect the RAID battery cable from the connector on the storage
card, press the tab on the RAID battery cable connector, and gently pull
the cable connector out of the connector on the storage card.
See Figure 3-15.
7
Pull the battery carrier release tab, and lift the battery carrier out of the
battery carrier slots on the chassis. See Figure 3-15.
8
Pull back gently on the two tabs holding the RAID battery and lift the
RAID battery from the battery carrier. See Figure 3-15.
book.book Page 119 Tuesday, June 9, 2009 4:09 PM