Filter
Top Products
124 Installing System Components
5
Disconnect all the cables from the system board and drives.
NOTE: Note the routing of the power cables as you disconnect the cables
from the system board and drives. You must route these cables properly when
you replace them to prevent them from being pinched or crimped.
6
Remove the screws that secure the power supply to the chassis and slide
the power supply out of the system. See Figure 3-17.
Figure 3-17. Removing and Installing a Non-Redundant Power Supply
1 screws (3)
1
book.book Page 124 Tuesday, June 9, 2009 4:09 PM