Filter
Top Products
Installing System Components 139
11
Press <F2> to enter the System Setup program, and check that the processor
information
matches the new system configuration. See "Entering the
System Setup Program."
12
Run the system diagnostics to verify that the new processor operates correctly.
See "Running the Embedded System Diagnostics" on page 174 for
information about running the diagnostics.
System Battery
Replacing the System Battery
WARNING: Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
WARNING: There is a danger of a new battery exploding if it is incorrectly
installed. Replace the battery only with the same or equivalent type recommended
by the manufacturer. See your safety information for additional info.
1
Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2
Rotate the system feet inward and lay the system on a flat surface.
3
Open the system. See "Opening the System" on page 90.
Figure 3-24. Replacing the System Battery
1 positive side of battery connector 2 system battery
3 negative side of battery connector
2
3
1
book.book Page 139 Tuesday, June 9, 2009 4:09 PM