Filter
Top Products
122 Installing System Components
Figure 3-16. Removing and Installing a Redundant Power Supply
Installing a Redundant Power Supply
1
Verify that both power supplies are the same type and have the same
maximum output power.
NOTE: The maximum output power (shown in watts) is listed on the power
supply label.
2
If you are installing a power supply into an empty bay, remove the power
supply blank. See "Removing a Power Supply Blank" on page 123.
If you are installing a power supply into a bay that has a power supply,
see "Removing a Redundant Power Supply" on page 121.
1 power supply handle 2 velcro strap
3 release latch
1
2
3
book.book Page 122 Tuesday, June 9, 2009 4:09 PM