Filter
Top Products
128 Installing System Components
Figure 3-19. Removing and Installing an iDRAC6 Express Card
Removing an iDRAC6 Express Card
WARNING: Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. Before you begin this
procedure, review the safety instructions that came with the system.
1
Turn off the system, including any attached peripherals, and disconnect
the system from its electrical outlet.
2
Rotate the system feet inward and lay the system on a flat surface.
3
Open the system. See "Opening the System" on page 90.
1 iDRAC6 Express card 2 retention standoff tab clip
3 iDRAC6 Express card connector 4 notch
5clip
1
24
5
3
book.book Page 128 Tuesday, June 9, 2009 4:09 PM