Filter
Top Products
x
■ Proper Care of the BHT and CU
Clean the housing and the battery cartridge terminals with a dry, soft cloth. Before
cleaning, be sure to power off the BHT and unplug the AC adapter of the CU.
• Never use benzene, alcohol, or other or-
ganic solvents. The housing may be
marred or the paint may come off.
• Never rub or strike the liquid crystal dis-
play (LCD) with anything hard. The LCD
surface will be easily scratched or bro-
ken.
• When cleaning the keypad, do not scrub
the surface too hard, and do not pull on
the keys. Doing so may break the keys
or cause the keypad to dislocate.
• If the BHT or CU becomes smudged, moisten a soft cloth with neutral detergent and
wring it out thoroughly. Wipe the BHT or CU with the cloth and then go over it
again with a dry cloth.
Dust or dirt accumulating on the clear plate of the bar-code reading window will affect
reading performance. If you use the BHT in dusty areas, therefore, periodically check
the clear plate of the bar-code reading window and clean it if dusty.
• To clean the plate, first blow the dust away with an air brush. Then wipe the plate
with a cotton swab or the similar soft one gently.
• If sand or hard particles have accumulated, never rub the plate; doing so will
scratch or damage it. Blow the particles away with an air brush or a soft brush.
■ Limited Warranty on Software Products
In no event will DENSO WAVE be liable for direct, indirect, special, incidental, or
consequential damages (including imaginary profits or damages resulting from inter-
ruption of operation or loss of business information) resulting from any defect in the
software or its documentation or resulting from inability to apply the software or its
documentation.
NO WAY!!
Take care of me
with a dry soft
cloth.
Thinner Benzine