Filter
Top Products
54
(1) Communications parameters setting screen
Selecting "1:PARAMETER" on the SET OPTICAL
screen calls up the screen shown at left.
Highlighted is the current setting.
Select the desired transmission speed by using
the numerical keys or
* and * keys, and
then press the ENT key.
To return to the SET OPTICAL screen, press the C
key.
(2) Communications protocol option screen
Selecting "2: PROTOCOL" on the SET OPTICAL
screen calls up the screen shown at left.
Highlighted is the current setting.
1 SERIAL No.: Selects whether or not the
system will add serial num-
bers to data blocks.
2 H. PARITY: Selects whether or not the
system will add a horizontal
parity.
3 LINKUP TIME: Selects the timeout length (in
seconds) to be applied when
a link is to be established.
4 FIELD SPACE: Selects whether space codes
in the tail of a data field will
be ignored or handled as data.
Select a desired item by using the numerical keys
or
* and * keys. Then select a desired set-
ting by using the
* and * keys.
To return to the SET OPTICAL screen, press the C
key.
If the BHT-Ir protocol has been selected, the
serial number and horizontal parity settings
will be ignored.
NOTE
SET PARAMETER
< OPTICAL >
1:TRANSMIT SPEED:
2400 9600 19200
38400 57600 115200
SET PROTOCOL
< OPTICAL >
1:SERIAL No. : ON OFF
2:H.PARITY : ON OFF
3:LINKUP TIME:
None 30 60 90 120
4:FIELD SPACE:
Ignore Data
* For BHT-7000s having a 26-key pad, use F5 , F6 , F7 and F8 keys instead of , ,
, and keys, respectively