Denso BHT-7000 Scanner User Manual


 
51
Chapter 2. Getting Started the BHT-7000 and System Mode
Minimum number of digits to be read for ITF, STF, or CODABAR (MINIMUM
DIGITS)
You may determine the minimum number of digits to be read for ITF, STF, and
CODABAR. Setting a small number of digits increases the frequency of digit-missing
reading or misreading depending upon how to scan bar codes or the quality of bar
codes. On the other hand, setting a large number will diminish the possibility of those
errors.
The setting range is from 2 to 20 for ITF, from 1 to 20 for STF, and from 3 to 20 for
CODABAR. The default is 4 for ITF and CODABAR, and 2 for STF.
MARKER
You may select either of the following ON/OFF modes of a laser beam (marker) which
indicates the scanning range:
0: Normal mode (in which the laser and illumination LED come on at the same time at
the time of scanning)
1: OFF mode (in which no laser comes on)
Even if the MARKER is set to 0 (Normal mode), the marker will not come on when
the read mode is set to the alternate switching mode or continuous reading mode.
TIP