Filter
Top Products
IMG 1010 - Hardware Installation
23
Connecting Ethernet and TDM Cables - IMG 1010
Topic Location: IMG 1010-Installation and Setup Guide > IMG 1010-Hardware
Installation
CAUTION: Routers or switches connected to the IMG 1010 should be configured for
100Mbit and Auto-negotiation. Disabling auto-negotiation may result in packet loss.
Also, broadcast propagation between ports must be enabled to allow BootP.
Network Interface Ports
There are three types of Network Interface ports on the IMG 1010:
Control (Network Management)
Data (RTP)
Signaling (H.323)
The IMG 1010 supports a variety of scenarios for designing your IP network. In this example,
the Network Management is connected to CTRL 0 and the VoIP interfaces to DATA 0. These
can be on either the same or different subnets.
For information on the various scenarios supported, see IMG 1010-Network Interface
Scenarios in the On-line Help.
TDM Bearer Channels and SS7 Signaling
In this example scenario, the Bearer ports are used for both bearer and signaling. Your SS7
Signaling can also be brought into the SIGNAL/TIMING port.
Related Topic
RJ 48 Connector Pinouts