D-Link 28F Switch User Manual


 
xStack
®
DES-3200-10/18/28/28F Layer 2 Ethernet Managed Switch User Manual
Parameter Description
Old Local Enable
Password (Max: 15
characters)
If a password was previously configured for this entry, enter it here in order to change it to
a new password
New Local Enable
Password
Enter the new password that you wish to set on the Switch to authenticate users
attempting to access Administrator Level privileges on the Switch. The user may set a
password of up to 15 characters.
Confirm Local Enable
Password
Confirm the new password entered above. Entering a different password here from the
one set in the New Local Enabled field will result in a fail message.
MAC-based Access Control
MAC-based Access Control is a method to authenticate and authorize access using either a port or host. For port-
based MAC, the method decides port access rights, while for host-based MAC, the method determines the MAC
access rights.
A MAC user must be authenticated before being granted access to a network. Both local authentication and remote
RADIUS server authentication methods are supported. In MAC-based Access Control, MAC user information in a local
database or a RADIUS server database is searched for authentication. Following the authentication result, users
achieve different levels of authorization.
Notes About MAC-based Access Control
There are certain limitations and regulations regarding the MAC-based Access Control:
1. Once this feature is enabled for a port, the Switch will clear the FDB of that port.
2. If a port is granted clearance for a MAC address in a VLAN that is not a Guest VLAN, other MAC addresses on
that port must be authenticated for access and otherwise will be blocked by the Switch.
3. Ports that have been enabled for Link Aggregation, Port Security, or GVRP authentication cannot be enabled for
MAC-based Authentication.
MAC-based Access Control Settings
The following window is used to set the parameters for the MAC-based Access Control function on the Switch. Here
the user can set the running state, method of authentication, RADIUS password, and view the Guest VLAN
configuration to be associated with the MAC-based Access Control function of the Switch.
To enable the MAC-based Access Control Global Settings on the Switch, click Security > MAC-based Access
Control > MAC-based Access Control Settings:
146