D-Link 28F Switch User Manual


 
xStack
®
DES-3200-10/18/28/28F Layer 2 Ethernet Managed Switch User Manual
Parameter Description
Interface Name
The name of the IPv6 interface being displayed or modified.
VLAN Name
Display the VLAN name of the IPv6 interface.
Admin. State
Display the current administrator state.
IPv6 Address
Enter the IPv6 address of the interface to be modified.
Automatic Link
Local Address
Toggle between Enabled and Disabled. Enabling this is helpful when no external source of network
addressing information is available.
NS Retransmit
Time (0-
4294967295)
Enter a value between 0 and 4294967295. This is the neighbor solicitation’s retransmit timer in
milliseconds. The default is zero.
IPv6 Route Settings
The user can configure the Switch’s IPv6 Route Table.
To view the following window, click Configuration > IPv6 Route Settings:
Figure 2 - 6. IPv6 Route Settings window
Enter an IP Interface, an IPv6 address in the Default Gateway field and then click the Create button. In addition, the
Metric can be entered between 1 and 65535. The new IPv6 route will be displayed in the table at the bottom of the
window.
IPv6 Neighbor Settings
The user can configure the Switch’s IPv6 neighbor settings. The Switch’s current IPv6 neighbor settings will be
displayed in the table at the bottom of this window.
To view the following window, click Configuration > IPv6 Neighbor Settings:
Figure 2 - 7. IPv6 Neighbor Settings window
Enter the Interface Name, Neighbor IPv6 Address, and the Link Layer MAC Address and then click the
Add
button.
To look for an IPv6 Neighbor Settings table entry, enter the Interface Name, select the desired State (All, Address, Static, or
Dynamic) in the middle section of this window, and then click the
Find
button.
To delete all the entries being displayed on the table at the bottom of this window, click the
Clear
button.
The following parameters may be configured or viewed:
17